Installing Switch Machine linkage


Step 1. Drill .040 hole in throwbar


Step 2. Drill 1/16th hole exactly 1/4th inch
from the hole you just drilled in the throwbar.
Same distance from the rail as the .040.


Step 3. Insert 1/16th tube down through hole
Then slip the rod down the tube and hook in place.


Step 4. Underneath the table the shaft is sticking straight down


Step 5. Bend the shaft over up to almost flush with the bottom


Step 6. Insert Mighty Mo's throw rod onto the bent over shaft.
be sure the base of the motor is up against the rod and centered
with the rod reaching across to throw the bent shaft. Put in the two screws.
Your done


Send E-Mail to Railway E-Mail if you want to know more.

You can use a check or credit card. . . through our PayPal order page.

The latest project Reverse Loop Module . . . Shop Railroad Railroad Pictures
Copyright © Railway Engineering all rights reserved