Step 2. Hook the double bent rod end into drilled hole from underneath
the tie. Center points then pencil a mark to the side of the bent up end of rod.
Step 3. Drill 1/16th hole down through the table .
on pencil mark. Keep it perpendicular
Step 4. Insert 1/16th tube with frog contacts up through hole
Step 5. Trim the tube to be flush on top and plate flush under table.
Step 6. Insert the shaft of the Hand Stand down through the tube.
Step 7. Insert stand all the way down with the throw rod
bent end coming up through the crank hole in the stand
Step 8. Insert the two spikes in the holes in the stand base.
Step 9. Test the handle on the Hand Stand be sure
the switch points throw both directions fully.
Center the points and put piece of masking tape to hold
Step 10. Underneath the table the shaft is sticking straight down
Step 11. Bend the shaft over up to almost flush with the bottom
That's it the stand will now throw your turnout back and forth.
You can solder wires from your stock rails to the two outside solder tabs
and the frog wire to the center of the pcboard for frog polarity.
Step 12. If you wish, you can add an RE switch machine to power your stand. Insert Mighty Mo's throw rod onto the bent over shaft. (underneath at the pcboard)
be sure the base of the motor is up against the plate and centered
with the rod reaching across to throw the bent shaft. Put in the two screws.